TOYOTA PARKING ASSIST-SENSOR SYSTEM > Front Clearance Sonar Sensor LH Circuit |

| 1.REPLACE NO. 2 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) |
Remove the No. 2 ultrasonic sensor (front corner sensor LH) (Click here).
Inspect the No. 2 ultrasonic sensor (front corner sensor LH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CORNER SENSOR RH) |
Disconnect the C2 No. 2 ultrasonic sensor (front corner sensor LH) connector.
Disconnect the B2 No. 2 ultrasonic sensor (front corner sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C2-1 (BI) - B2-2 (BO) | Always | Below 1 Ω |
| C2-3 (SI) - B2-4 (SO) | Always | Below 1 Ω |
| C2-5 (EI) - B2-6 (EO) | Always | Below 1 Ω |
| C2-1 (BI) or B2-2 (BO) - Body ground | Always | 10 kΩ or higher |
| C2-3 (SI) or B2-4 (SO) Body ground | Always | 10 kΩ or higher |
| C2-5 (EI) or B2-6 (EO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||