TOYOTA PARKING ASSIST-SENSOR SYSTEM > Rear Clearance Sonar Sensor LH Circuit |

| 1.INSPECT NO. 2 ULTRASONIC SENSOR (REAR CORNER SENSOR LH) |
Remove the No. 2 ultrasonic sensor (rear corner sensor LH) (Click here).
Inspect the No. 2 ultrasonic sensor (rear corner sensor LH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR LH - REAR CENTER SENSOR LH) |
Disconnect the R5 No. 2 ultrasonic sensor (rear corner sensor LH) connector.
Disconnect the R8 No. 2 ultrasonic sensor (rear center sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R5-1 (BI) - R8-2 (BO) | Always | Below 1 Ω |
| R5-3 (SI) - R8-4 (SO) | Always | Below 1 Ω |
| R5-5 (EI) - R8-6 (EO) | Always | Below 1 Ω |
| R5-1 (BI) or R8-2 (BO) - Body ground | Always | 10 kΩ or higher |
| R5-3 (SI) or R8-4 (SO) - Body ground | Always | 10 kΩ or higher |
| R5-5 (EI) or R8-6 (EO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||