GENERATOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.
Tighten the radiator drain cock plug by hand.

| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 5. REMOVE INLET RADIATOR HOSE |
![]() |
Remove the inlet radiator hose.
| 6. DISCONNECT OUTLET RADIATOR HOSE |
![]() |
Disconnect the outlet radiator hose from the water inlet housing.
| 7. REMOVE FAN SHROUD |
![]() |
Loosen the 4 nuts holding the fluid coupling and fan.
Remove the fan and generator V belt .
![]() |
Detach the claw to open the No. 1 flexible hose clamp.
![]() |
Disconnect the reservoir hose from the upper radiator tank.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the fan bracket.
| 8. REMOVE FRONT FENDER APRON SEAL RH |
Remove the 6 clips and fender apron seal.
| 9. DISCONNECT VANE PUMP ASSEMBLY |
![]() |
Disconnect the clamp and 2 power steering connectors.
![]() |
Remove the 2 bolts and disconnect the vane pump.
| 10. REMOVE GENERATOR ASSEMBLY |
![]() |
Disconnect the generator connector.
Remove the terminal cap and nut, and disconnect the generator wire.
Remove the bolt and disconnect the wire harness bracket from the generator.
![]() |
Remove the 3 bolts, nut and generator.