POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function Via Back Door Lock Key Cylinder does not Operate |

| 1.CHECK BACK DOOR WINDOW OPERATION |
Check that the back door power window operates via the back door power window switch.
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Back Door P/W / Data List.
According to the display on the intelligent tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Switch Operation Locked | Tail gate control switch signal / ON or OFF | ON: Tail gate control switch is turned to lock OFF: Key is in back door lock key cylinder (original position) | - |
| Key Switch Operation Unlocked | Tail gate control switch signal / ON or OFF | ON: Tail gate control switch is turned to unlock OFF: Key is in back door lock key cylinder (original position) | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT TAIL GATE CONTROL SWITCH |
![]() |
Remove the tail gate control switch .
Insert the key into the key cylinder.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (L) - 3 (E) | Turn key to lock position | Below 1 Ω |
| Turn key to unlock position | 10 kΩ or higher | |
| 2 (UL) - 3 (E) | Turn key to unlock position | Below 1 Ω |
| Turn key to lock position | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT HARNESS AND CONNECTOR (BACK DOOR ECU - TAIL GATE CONTROL SWITCH) |
![]() |
Disconnect the V3 back door ECU connector.
Disconnect the V18 tail gate control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| V3-7 (BKUL) - V18-2 (UL) | Always | Below 1 Ω |
| V3-8 (BKL) - V18-1 (L) | Always | Below 1 Ω |
| V3-19 (KEYE) - V18-3 (E) | Always | Below 1 Ω |
| V18-1 (L) - Body ground | Always | 10 kΩ or higher |
| V18-2 (UL) - Body ground | Always | 10 kΩ or higher |
| V18-3 (E) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||