Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the radio and display receiver assembly.
It also supplies power from the radio and display receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E280091E16


INSPECTION PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    E280108E33
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-18 (SGND) - Body ground
    Always
    Below 1 Ω
    I58-19 (MIN-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I58-4 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

Text in Illustration 
*a
Component with harness connected
(Radio and Display Receiver Assembly)


NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the I58 radio and display receiver assembly connector.

  1. Disconnect the U7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-4 (MACC) - U7-10 (ACC)
    Always
    Below 1 Ω
    I58-5 (MIN+) - U7-9 (MIC+)
    Always
    Below 1 Ω
    I58-19 (MIN-) - U7-8 (MIC-)
    Always
    Below 1 Ω
    I58-6 (SNS2) - U7-14 (SGND)
    Always
    Below 1 Ω
    I58-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    I58-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    I58-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    I58-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    I58-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the television display assembly with a known good one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Short Type Overhead Console Box)
    B
    NG (for Long Type Overhead Console Box)
    C



B
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)

C
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
A

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)