Home › Engine / Hybrid System › 3UR-FE STARTING › STARTER

STARTER > INSTALLATION

for Preparation Click here



1. INSTALL FLYWHEEL HOUSING SIDE COVER


A163323


2. INSTALL STARTER ASSEMBLY
  1. Install the starter with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Install the starter wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.

  1. Attach the 2 wire harness clamps.



3. INSTALL STARTER COVER


    A162756
  1. Install the starter cover with the 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(Click here)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).