Home › Engine / Hybrid System › 3UR-FE STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
  1. Remove the exhaust manifold sub-assembly RH (Click here).



3. REMOVE STARTER COVER


    A162756
  1. Remove the 3 bolts and starter cover.



4. REMOVE STARTER ASSEMBLY


    A162757
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A162755
  1. Remove the 2 bolts and starter.



5. REMOVE FLYWHEEL HOUSING SIDE COVER


A162758