POWER MIRROR CONTROL SYSTEM (w/ Memory) > Power Mirror Surface Position is not Memorized |
| 1.CHECK FOR DTC |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.CHECK SEAT MEMORY SWITCH FUNCTION (SEAT POSITION MEMORY FUNCTION) |
Check that the driver side seat can be moved using the seat memory switch.
|
| ||||
| OK | |
| 3.CHECK SEAT MEMORY SWITCH FUNCTION (REGISTRATION OF SEAT MEMORY SWITCH) |
Check that the memory operation is properly completed.
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING INTELLIGENT TESTER (MIRROR POSITION MEMORY) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Mirror / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Display | Normal Condition | Diagnostic Note |
| Mirror Memory No. 1 | Mirror position memorized in seat memory switch 1 / ON or OFF | ON: Memorized OFF: Not memorized | - |
| Mirror Memory No. 2 | Mirror position memorized in seat memory switch 2 / ON or OFF | ON: Memorized OFF: Not memorized | - |
|
| ||||
| OK | ||
| ||