WIPER AND WASHER SYSTEM > Headlight Cleaner Motor and Relay Circuit |

| 1.INSPECT FUSE (ECU-IG No. 2, H-LP CLN) |
![]() |
Remove the ECU-IG No. 2 fuse from the main body ECU.
Remove the H-LP CLN fuse from the engine junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 2 fuse | Always | Below 1 Ω |
| H-LP CLN fuse |
Reinstall the ECU-IG No. 2 fuse.
Reinstall the H-LP CLN fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A32 headlight cleaner control relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A32-3 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A32-4 (E) - Body ground | Always | Below 1 Ω |
Reconnect the headlight cleaner control relay connector.
|
| ||||
| OK | |
| 3.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
![]() |
Remove the headlight cleaner motor and pump assembly (Click here).
Apply battery voltage to the headlight cleaner motor and pump assembly and check the operation of the headlight cleaner motor and pump assembly.
| Measurement Connection | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Headlight cleaner motor operation is normal |
Reinstall the headlight cleaner motor and pump assembly.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CLEANER MOTOR - HEADLIGHT CLEANER CONTROL RELAY AND BATTERY) |
![]() |
Disconnect the A30 headlight cleaner motor and pump connector.
Disconnect the A32 headlight cleaner control relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-1 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-2 - A32-6 (PB) | Always | Below 1 Ω |
| A30-2 or A32-6 (PB) - Body ground | Always | 10 kΩ or higher |
Reconnect the headlight cleaner motor and pump connector.
Reconnect the headlight cleaner control relay connector.
|
| ||||
| OK | ||
| ||