CYLINDER HEAD GASKET > REMOVAL |
| 1. REMOVE EXHAUST MANIFOLD |
Remove the exhaust manifold (Click here).
| 2. REMOVE CAMSHAFT |
Remove the camshaft (Click here).
| 3. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY |
Remove the 32 valve rocker arms from the cylinder head.
| 4. REMOVE VALVE LASH ADJUSTER ASSEMBLY |
Remove the 32 valve lash adjusters from the cylinder head.
| 5. REMOVE VALVE STEM CAP |
Remove the 32 valve stem caps from the cylinder head.
| 6. REMOVE CYLINDER HEAD LH |
![]() |
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
![]() |
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
| 7. REMOVE NO. 2 CYLINDER HEAD GASKET |
| 8. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
![]() |
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
| 9. REMOVE CYLINDER HEAD GASKET |