Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2322    Front Passenger Side Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the front power window regulator motor assembly RH and main body ECU stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2322
No communication between the front power window regulator motor assembly RH and main body ECU for 10 seconds or more.
  1. Front power window regulator motor assembly RH
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


B173719E45


INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2325 is stored when the communication between the front power window regulator motor assembly RH and main body ECU stops.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REGULATOR MOTOR RH)


    E160671E02
  1. Disconnect the H2 main body ECU connector.

  1. Disconnect the L3 front power window regulator motor assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H2-10 (LIN2) - L3-9 (LIN)
    Always
    Below 1 Ω

  1. Reconnect the main body ECU connector.

  1. Reconnect the front power window regulator motor assembly RH connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (REGULATOR MOTOR RH - BATTERY AND BODY GROUND)


    E160672E04
  1. Disconnect the L3 front power window regulator motor assembly RH connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L3-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L3-2 (B) - Body ground
    Always
    11 to 14 V

  1. Reconnect the front power window regulator motor assembly RH connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
  1. Temporarily replace the front power window regulator motor assembly RH with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B2322 is not output
    A
    DTC B2322 is output
    B



B
REPLACE MAIN BODY ECU
A

END (FRONT POWER WINDOW REGULATOR MOTOR RH IS DEFECTIVE)