COMBINATION METER > INSTALLATION |
| 1. INSTALL COMBINATION METER ASSEMBLY |
![]() |
Connect the connector and engage the clip and install the combination meter assembly.
![]() |
Install the 4 screws.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Attach the 12 clips to install the finish panel.
Connect the 2 connectors and clamp.
![]() |
Attach the 4 claws to install the instrument panel finish panel retainer.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Attach the 2 claws to install the sensor.
![]() |
Connect the connectors.
Attach the 9 clips and claw to install the finish panel.
Install the 2 <A> bolts.
| 4. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 7 claws to install the side panel.
| 5. INSTALL COWL SIDE TRIM BOARD LH |
| 6. INSTALL FRONT DOOR SCUFF PLATE LH |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).