Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    B166433
  1. Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    B166432
  1. Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE STEERING PAD


    C180934
  1. Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

  1. Pull the steering pad toward you.



    B166581
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the 2 connectors.

  1. Disconnect the horn connector.



5. REMOVE CRUISE CONTROL MAIN SWITCH


    B160019E01
  1. Disconnect the connector.

  1. Remove the 2 screws and switch.