CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Skid Control ECU Communication Stop Mode | When either condition below is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE) |
![]() |
Disconnect the A19 skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-12 (CANH) - A19-13 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Reconnect the cable to the negative (-) battery terminal.
Disconnect the A19 skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-16 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-1 (+BM) - Body ground | Always | 11 to 14 V |
| A19-32 (+BS) - Body ground | ||
| A19-8 (IG1) - Body ground | Ignition switch ON |
|
| ||||
| OK | ||
| ||