Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

DTC    U0199    Lost Communication with "Door Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0199
No communication from outer mirror control ECU
  1. Power source circuit of outer mirror control ECU
  2. Outer mirror control ECU
  3. Outer mirror control ECU branch wire or connector
w/ Seat Memory

WIRING DIAGRAM


C158947E08


C158947E09


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any other switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (OUTER MIRROR CONTROL ECU BRANCH WIRE)


    C159487E16
  1. Disconnect the M8 outer mirror control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    M8-1 (CAN) - M8-21 (CGND)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE OUTER MIRROR CONTROL ECU BRANCH WIRE OR CONNECTOR (CAN, CGND)
OK


3.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU - BATTERY AND BODY GROUND)
  1. Reconnect the cable from the negative (-) battery terminal.



    C159593E04
  1. Disconnect the M7 outer mirror control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M7-9 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    M7-3 (B) - Body ground
    Always
    11 to 14 V
    M7-4 (ACC) - Body ground
    Ignition switch ACC



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE OUTER MIRROR CONTROL ECU (Click here)