DTC U0208 Lost Communication with "Seat Control Module A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0208 | No communication from power seat control ECU |
|


| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (POWER SEAT CONTROL ECU BRANCH WIRE) |
![]() |
Disconnect the X11 power seat control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| X11-5 (CANH) - X11-1 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SEAT CONTROL ECU - BATTERY AND BODY GROUND) |
Reconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the X10 and X11 power seat control ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| X10-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| X10-5 (+B) - Body ground | Always | 11 to 14 V |
| X11-8 (SYSB) - Body ground | ||
| X11-4 (IG) - Body ground | Ignition switch ON |
|
| ||||
| OK | ||
| ||