Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

DTC    U0208    Lost Communication with "Seat Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0208
There is no communication from the front power seat switch LH (power seat control ECU).
  1. Power source or inside front power seat switch LH (power seat control ECU)
  2. Front power seat switch LH (power seat control ECU) CAN branch wire or connector
  3. Front power seat switch LH (power seat control ECU)
For vehicles with an seat memory.

WIRING DIAGRAM


C245284E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the CAN main wire or CAN branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT SWITCH LH CAN BRANCH WIRE)


    C245285E01
  1. Disconnect the X11 front power seat switch LH (power seat control ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    X11-5 (CANH) - X11-1 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Front Power Seat Switch LH [Power Seat Control ECU])



NG
REPAIR OR REPLACE FRONT POWER SEAT SWITCH LH CAN BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND)


    C245286E01
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the X10 front power seat switch LH (power seat control ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    X10-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    X10-5 (+B) - Body ground
    Always
    11 to 14 V
    X11-8 (SYSB) - Body ground
    Always
    11 to 14 V
    X11-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Front Power Seat Switch LH [Power Seat Control ECU])


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT SWITCH LH (POWER SEAT CONTROL ECU) (Click here)