DTC B1413/13 Evaporator Temperature Sensor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1413/13 | An open or short in evaporator temperature sensor circuit. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (NO. 1 COOLER THERMISTOR) |
Use the Data List to check if the No. 1 cooler thermistor (evaporator temperature sensor) is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Evaporator Fin Thermistor | No. 1 cooler thermistor / Min.: -29.7°C (-21.46°F) Max.: 59.55°C (139.19°F) | Actual evaporator temperature is displayed | Open in the circuit: -29.7°C (-21.46°F) Short in the circuit: 59.55°C (139.19°F) |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC output) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR) |
![]() |
Remove the No. 1 cooler thermistor (evaporator temperature sensor) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | -10°C (14°F) | 7.30 to 9.10 kΩ |
| -5°C (23°F) | 5.65 to 6.95 kΩ | |
| 0°C (32°F) | 4.40 to 5.35 kΩ | |
| 5°C (41°F) | 3.40 to 4.15 kΩ | |
| 10°C (50°F) | 2.70 to 3.25 kΩ | |
| 15°C (59°F) | 2.14 to 2.58 kΩ | |
| 20°C (68°F) | 1.71 to 2.05 kΩ | |
| 25°C (77°F) | 1.38 to 1.64 kΩ | |
| 30°C (86°F) | 1.11 to 1.32 kΩ |
|
| ||||
| OK | |
| 3.CHECK AIR CONDITIONING HARNESS ASSEMBLY (EVAPORATOR TEMPERATURE SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Remove the air conditioning harness assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (SGB) - z13-5 (SGA) | Always | Below 1 Ω |
| 2 (TEB) - z13-6 (TEA) | Always | Below 1 Ω |
| 1 (SGB) - z13-6 (TEA) | Always | 10 kΩ or higher |
| 2 (TEB) - z13-5 (SGA) | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||