DTC B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1441/41 | The air mix damper position does not change even if the air conditioning amplifier assembly operates the air mix servo motor. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (PASSENGER SIDE AIR MIX SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Targ Pulse (P) | Passenger side air mix servo motor / Min.: 0 Max.: 255 | MAX. COLD: 105 (pulse) MAX. HOT: 6 (pulse) | - |
| Result | Proceed to |
| OK (When troubleshooting according to the DTC output) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE DAMPER SERVO SUB-ASSEMBLY (for Front Passenger Side) |
Replace the damper servo sub-assembly (for front passenger side) (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||