DTC B1442/42 Air Inlet Damper Control Servo Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1442/42 | The recirculation damper position does not change even if the air conditioning amplifier assembly operates the recirculation damper servo motor. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (AIR INLET DAMPER SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Inlet Damper Targ Pulse | Air inlet damper servo motor / Min.: 0 Max.: 255 | Recirculation: 7 Fresh: 28 | - |
Visually inspect the air inlet damper servo motor.
Visually inspect whether the air inlet damper servo motor operates.
| Result | Proceed to |
| The Data List value changes and the air inlet damper servo motor operates (When troubleshooting according to the DTC output) | A |
| The Data List value changes and the air inlet damper servo motor operates (When troubleshooting according to Problem Symptoms Table) | B |
| The Data List value does not change and the air inlet damper servo motor does not operate | C |
| The Data List value changes, but the air inlet damper servo motor does not operate | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK RECIRCULATION DAMPER SERVO SUB-ASSEMBLY |
Replace the recirculation damper servo sub-assembly (Click here).
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY |
Replace the air conditioning harness assembly (Click here).
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||