DTC B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1446/46 | The air mix damper position does not change even if the air conditioning amplifier assembly operates the air mix servo motor. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (DRIVER SIDE AIR MIX SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor / Min.: 0 Max.: 255 | MAX. COLD: 5 (pulse) MAX. HOT: 104 (pulse) | - |
Visually inspect the driver side air mix servo motor.
Visually inspect whether the driver side air mix servo motor operates.
| Result | Proceed to |
| The Data List value changes and the driver side air mix servo motor operates (When troubleshooting according to the DTC output) | A |
| The Data List value changes and the driver side air mix servo motor operates (When troubleshooting according to Problem Symptoms Table) | B |
| The Data List value does not change and the driver side air mix servo motor does not operate | C |
| The Data List value changes, but the driver side air mix servo motor does not operate | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (DAMPER SERVO MOTOR ASSEMBLY [FOR DRIVER SIDE]) |
Replace the cooling unit damper servo sub-assembly (damper servo motor assembly [for driver side]) (Click here).
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY |
Replace the air conditioning harness assembly (Click here).
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||