AIR CONDITIONING SYSTEM > Blower Motor Circuit |


| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BLOWER MOTOR) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the blower with fan motor sub-assembly operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Blower Motor | Blower motor | Min.: 0, Max.: 31 | - |
| Result | Proceed to |
| OK (Blower motor operates normally) | A |
| NG (Blower motor does not operate) | B |
| NG (Blower motor operates but does not change speed) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.INSPECT FUSE (HTR) |
![]() |
Remove the HTR fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| HTR fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (BLOWER MOTOR - BATTERY AND BODY GROUND) |
![]() |
Disconnect the H41 motor connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H41-3 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| H41-1 (+B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BLOWER MOTOR) |
![]() |
Disconnect the H24 amplifier connector.
Disconnect the H41 motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H24-23 (BLW) - H41-2 (SI) | Always | Below 1 Ω |
| H24-23 (BLW) or H41-2 (SI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK BLOWER WITH FAN MOTOR SUB-ASSEMBLY (S1 VOLTAGE) |
![]() |
Disconnect the H24 amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H24-23 (BLW) - Body ground | Ignition switch ON | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 6.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (BLW VOLTAGE) |
![]() |
Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Check the waveform of the air conditioning amplifier connector.
| Item | Content |
| Terminal No. (Symbol) | H24-23 (BLW) - H24-14 (GND) |
| Tool Setting | 1 V/DIV, 500 μsec./DIV. |
| Condition | Ignition switch ON Blower switch lo |
|
| ||||
| OK | ||
| ||