Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER

AIR CONDITIONING AMPLIFIER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



3. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



4. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



6. REMOVE LOWER INSTRUMENT PANEL


    B226759
  1. Remove the screw and bolt.

  1. Detach the 2 claws and remove the panel.



7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226007
  1. Remove the 3 bolts and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



9. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


I104452
  1. Disconnect the 2 connectors.

  1. Remove the 2 screws and amplifier.