Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER

AIR CONDITIONING AMPLIFIER > INSTALLATION

for Preparation Click here



1. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY


I104452
  1. Install the amplifier with the 2 screws.

  1. Connect the 2 connectors.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
  1. Connect the connector.

  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 <D> screws and bolt <A>.



3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226008
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the 3 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL
  1. Attach the 2 claws to install the panel.

  1. Install the bolt <A> and screw <D>.



5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 2 guides and 4 claws.

  1. Attach the clip to install the under cover.



6. INSTALL INSTRUMENT SIDE PANEL RH


    B229198
  1. Attach the 6 claws to install the side panel.



7. INSTALL COWL SIDE TRIM BOARD RH


    B190152
  1. Attach the 2 clips to install the cowl side trim board.

  1. Install the clip.



8. INSTALL FRONT DOOR SCUFF PLATE RH


B190151
  1. Attach the 9 claws to install the scuff plate.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable systems need to be initialized after the cable is reconnected (Click here).



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).