Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B279A    Theft Deterrent System Communication Line High Fixation

for Preparation Click here


DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU is stuck on HI output, the ECM outputs this DTC.

DTC Code
DTC Detection Condition
Trouble Area
B279A
When communication line (EFIO-IMI) between ECM and transponder key ECU is stuck on HI output for 6 seconds or more
  1. Harness or connector
  2. Transponder key ECU
  3. ECM

WIRING DIAGRAM


B160072E10


INSPECTION PROCEDURE

HINT:
When the transponder key ECU and/or ECM is replaced, reregister the ECU - ECM communication ID.

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC B279A is output
    A
    DTC B279A and other DTCs are output
    B

    HINT:
    If any DTCs other than B279A are output, troubleshoot those DTCs first.



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    B129773E08
  1. Disconnect the H32 ECU connector.

  1. Disconnect the A27 ECM connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-13 (EFIO) - A27-40 (IMI)
    Always
    Below 1 Ω
    H32-13 (EFIO) or A27-40 (IMI) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H32-13 (EFIO) - Body ground
    Always
    Below 1 V
    A27-40 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT TRANSPONDER KEY ECU (OUTPUT)


    B169769E03
  1. Measure the waveform.
    Waveform 1 
    Terminal No. (Symbol)
    Tool Setting
    Switch Condition
    H32-13 (EFIO) - H32-16 (GND)
    10 V/DIV., 500 msec./DIV.
    Ignition switch ON

    OK:
    Waveform is output normally (see illustration).

    Result 
    Result
    Proceed to
    Waveform is not output normally
    A
    Waveform is output normally
    B



B
REPLACE ECM (Click here)
A


5.CHECK TRANSPONDER KEY ECU (POWER SOURCE AND BODY GROUND)
B128338E36
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H32-1 (+B) - H32-16 (GND)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU