SPIRAL CABLE > INSTALLATION |
| 1. INSTALL SPIRAL CABLE |
![]() |
Attach the 3 claws to install the spiral cable with steering sensor.
Connect the connectors to the spiral cable with steering sensor.
| 2. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 4. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 5. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
| *a | Matchmark |
Install the steering wheel set nut.
| 6. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Support the steering pad with one hand.
![]() |
Connect the 2 airbag connectors to the steering pad.
Push in the 2 connector locks to install the 2 airbag connectors.
Connect the horn connector to the steering pad.
Install the steering pad.
![]() |
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 7. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the guide and claw to install the lower No. 3 steering wheel cover.
| 8. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the guide and claw to install the lower No. 2 steering wheel cover.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the top surface or in the grooved portion of the steering pad.
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
| 11. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).