Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel sub-assembly (Click here).



3. REMOVE NO. 1 HEATER TO REGISTER DUCT
  1. Detach the clamp.



  1. Remove the 5 screws and duct.


    B192352



4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B192372
  1. Remove the 2 screws.

  1. Detach the 2 clamps.

  1. Detach the 10 hooks and remove the front passenger airbag from the instrument panel.



    B192373E01
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the 2 airbag connectors and remove the instrument panel wire.