STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > INSTALLATION |
| 1. INSTALL STEERING COLUMN ASSEMBLY |
![]() |
Install the steering column with the bolt and 2 nuts.
Connect the connectors and wire harness clamps.
| 2. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY |
![]() |
Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.
Install the bolt.
| 3. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.
Install the bolt.
![]() |
Align the matchmarks on the steering column and steering intermediate shaft.
Install the bolt.
![]() |
Install the 3 bolts and nut.
| 4. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY |
![]() |
Install the air duct with the bolt.
| 5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY |
![]() |
Connect the connector.
Attach the 2 claws to install the DLC3.
Install the 4 bolts to install the instrument panel airbag.
| 6. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 7 claws to install the side panel.
| 7. INSTALL COWL SIDE TRIM BOARD LH |
| 8. INSTALL FRONT DOOR SCUFF PLATE LH |
| 9. INSTALL COMBINATION SWITCH |
![]() |
Install the turn signal switch with spiral cable to the steering column with the clamp.
![]() |
Connect the 6 connectors to the turn signal switch with spiral cable.
| 10. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 11. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 12. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 13. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 14. INSPECT STEERING WHEEL CENTER POINT |
| 15. INSTALL STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 16. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 17. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 19. INSPECT SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 20. CUSTOMIZE INFORMATION |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Utility / Customize Setting / Tilt & Telesco.
Turn the auto away/return function ON.