LIGHTING SYSTEM > Headlight Dimmer Switch Circuit |

| 1.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (TURN SIGNAL SWITCH) |
![]() |
Remove the headlight dimmer switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 13 (TR) - 12 (EL) | Turn signal switch right turn | Below 1 Ω |
| Turn signal switch left turn | 10 kΩ or higher | |
| 15 (TL) - 12 (EL) | Turn signal switch left turn | Below 1 Ω |
| Turn signal switch right turn | 10 kΩ or higher |
Reinstall the headlight dimmer switch assembly.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH - TURN SIGNAL FLASHER AND BODY GROUND) |
![]() |
Disconnect the H11 headlight dimmer switch assembly connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H11-13 (TR) - H39-7 (ER) | Always | Below 1 Ω |
| H11-15 (TL) - H39-6 (EL) | Always | Below 1 Ω |
| H11-12 (EL) - Body ground | Always | Below 1 Ω |
| H11-13 (TR) - Body ground | Always | 10 kΩ or higher |
| H11-15 (TL) - Body ground | Always | 10 kΩ or higher |
Reconnect the turn signal flasher assembly connector.
Reconnect the headlight dimmer switch assembly connector.
|
| ||||
| OK | ||
| ||