Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1445/45    Passenger Side Cool Air Bypass Damper Control

for Preparation Click here


DESCRIPTION

The cool air bypass damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal, reverse) based on the signals to move the cool air bypass damper to any position. As a result, when the air conditioning system is operating, the temperature of the air blowing toward the head area is controlled.

HINT:
  1. Although the intelligent tester title says "Passenger Side", there is only one cool air bypass servo motor on this vehicle.
  2. Confirm that no mechanical problem is present because this diagnostic trouble code can be stored when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1445/45
The cool air bypass damper servo motor position does not change even if the air conditioning amplifier assembly operates the cool air bypass damper servo motor.
  1. Damper servo sub-assembly (cool air bypass damper servo motor)
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM


E180810E11


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (COOL AIR BYPASS DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Cool Air Bypass Pulse
    Cool air bypass damper servo motor
    Min.: 0
    Max.: 255
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to the DTC output)
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A


2.REPLACE DAMPER SERVO SUB-ASSEMBLY (COOL AIR BYPASS DAMPER SERVO MOTOR)
  1. Replace the cool air bypass damper servo motor (Click here).

    HINT:
    Since the damper servo motor cannot be inspected while it is removed from the vehicle, replace the damper servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1445 is not output.



NG
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
OK

END (COOL AIR BYPASS DAMPER SERVO MOTOR IS FAULTY)