HARD DISK DRIVE > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL HARD DISK DRIVE |
![]() |
Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.
Attach the 2 guides to temporarily install the cover.
Install the cover with the 2 screws.
| 3. INSTALL NO. 1 RADIO BRACKET |
![]() |
Install the bracket with the 4 bolts.
| 4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET |
Connect the connectors.
![]() |
Insert the navigation receiver as shown in the illustration to attach the 3 clips on its backside.
![]() |
Install the navigation receiver with the 4 bolts.
| 5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Connect the connectors.
Attach the 4 clips and install the panel.
| 6. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL |
Connect the connectors.
Attach the 4 clips and 2 claws to install the finish panel.
| 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Attach the 12 clips to install the finish panel.
Connect the 2 connectors and clamp.
Attach the 4 claws to install the instrument panel finish panel retainer.
| 8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Connect the connectors.
Attach the 6 clips to install the console panel.
Install the clip.
| 9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Attach the 12 clips to install the console panel.
| 10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob and twist it in the direction indicated by the arrow.
| 11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Attach the 2 claws to install the sensor.
Connect the connectors.
Attach the 9 clips and claw to install the finish panel.
Install the 2 <A> bolts.
| 12. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 7 claws to install the side panel.
| 13. INSTALL COWL SIDE TRIM BOARD LH |
| 14. INSTALL FRONT DOOR SCUFF PLATE LH |
| 15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |