Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE

HARD DISK DRIVE > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
  1. Precautions for navigation receiver assembly and hard disk drive (Click here).
  2. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



4. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Detach the 12 clips and remove the console panel.



9. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector.



10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Detach the 4 claws and remove the instrument panel finish panel retainer.



    B219715
  1. Disconnect the 2 connectors and wire harness clamp.

  1. Detach the 12 clips and remove the finish panel.



11. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


    B223270
  1. Detach the 4 clips and 2 claws.

  1. Disconnect the connectors and remove the finish panel.



12. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    I104352
  1. Detach the 4 clips and separate the panel.

  1. Disconnect the connectors and remove the panel.



13. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


E260240
  1. Remove the 4 bolts.



    E260241
  1. Pull the navigation receiver as shown in the illustration to detach the 3 clips on the backside of the navigation receiver.

  1. Disconnect the connectors and remove the navigation receiver.



14. REMOVE NO. 1 RADIO BRACKET


E260242
  1. Remove the 4 bolts and bracket.



15. REMOVE HARD DISK DRIVE


    E260245
  1. Remove the 2 screws.

  1. Detach the 2 guides to remove the cover.



    E260246
  1. Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.