Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSTALLATION

for Preparation Click here



1. INSTALL STEERING WHEEL PAD ATTACHING SCREW


    C180961
  1. Install the 2 steering wheel pad attaching screws.



2. INSTALL CRUISE CONTROL MAIN SWITCH


    C180958
  1. Install the cruise control main switch with the 2 screws.



3. INSTALL STEERING PAD COVER RH (w/o Steering Pad Switch)


    C180959
  1. Attach the 2 pins to install the steering pad cover RH with the screw.



4. INSTALL STEERING PAD COVER LH (w/o Steering Pad Switch)


    C180960
  1. Attach the 2 pins to install the steering pad cover RH with the screw.



5. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)


C180957
  1. Attach the 4 pins to install the switch with the 2 screws.

  1. Connect the connector.



6. ADJUST SPIRAL CABLE


    B166449
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.

    NOTICE:
    Do not turn the spiral cable with steering sensor by the airbag wire harness.



    B166450
  1. Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not turn the spiral cable with spiral sensor by the airbag wire harness.

    HINT:
    The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.



7. INSTALL STEERING WHEEL ASSEMBLY


    C181135E01
  1. Align the matchmarks on the steering wheel and steering main shaft.

  1. Install the steering wheel set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



8. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    B166432
  1. Attach the 2 claws to install the cover.



9. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    B166433
  1. Attach the 2 claws to install the cover.



10. INSTALL STEERING PAD
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Check that the horn sounds.
    If the horn does not sound, inspect the horn system.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



12. INSPECT STEERING PAD


13. INSPECT SRS WARNING LIGHT
  1. Inspect SRS warning light (Click here).