Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning buzzer is installed in the accessory meter assembly.

WIRING DIAGRAM


E300604E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - ACCESSORY METER ASSEMBLY AND BATTERY)
  1. Disconnect the H131 clearance warning ECU assembly connector.

  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H131-2 (ER) - I22-11 (BZ)
    Always
    Below 1 Ω
    H131-2 (ER) or I22-11 (BZ) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I22-23 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK ACCESSORY METER ASSEMBLY
  1. Replace the accessory meter assembly with a normally functioning or new one (Click here).

  1. Check that the clearance warning buzzer operates normally.

    OK:
    Clearance warning buzzer operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (ACCESSORY METER ASSEMBLY IS DEFECTIVE)