Home › Steering › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column)

MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > INSTALLATION

for Preparation Click here



1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


C159704
  1. Install the ECU with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Connect the 2 ECU connectors.



2. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY


C154523
  1. Remove the bolt and air duct.



3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B163883
  1. Attach the 2 claws to install the sensor.



    B229064
  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



5. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. Attach the 3 claws to install the hood lock lever



6. INSTALL LOWER STEERING COLUMN COVER


C160536
  1. Attach the 2 claws to install the steering column lower cover.



7. INSTALL UPPER STEERING COLUMN COVER


C162097
  1. Attach the claw to install the upper steering column cover.

  1. Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.



    C180937
  1. Install the 2 screws.

    HINT:
    Turn the steering wheel to the right and left as necessary to install the 2 screws.



8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).