Home › Audio / Visual / Telematics › AUDIO / VIDEO › TELEVISION DISPLAY

TELEVISION DISPLAY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here ).



3. REMOVE ROOM NO. 1 LIGHT ASSEMBLY


    B193035E01
  1. Using a moulding remover D, detach the 4 clips.



    B191797
  1. Disconnect the connector and then remove the No. 1 room light assembly.



4. REMOVE TELEVISION DISPLAY ASSEMBLY


    B321163
  1. Detach the clamp.

  1. Disconnect the connector.



    E260243
  1. Remove the 4 bolts.

  1. Detach the 2 clips and remove the television display.



5. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


6. REMOVE TELEVISION DISPLAY BRACKET


E161065
  1. Remove the 4 bolts.

  1. Detach the clip and 2 claws, and remove the bracket.