DTC B1447/47 Rear Air Mix Damper Control Servo Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1447/47 | The rear air mix damper position does not change even if the air conditioning amplifier assembly operates the rear air mix damper servo motor. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (REAR AIR MIX SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Targ Pulse (R) | Rear air mix servo motor / Min.: 0, Max.: 255 | Customized value displayed | - |
| Result | Proceed to |
| OK (When troubleshooting according to the DTC output) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the P9 No. 2 air conditioning harness assembly connector.
Disconnect the H67 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P9-2 (RBUG) - H67-21 (RBUG) | Always | Below 1 Ω |
| P9-3 (RBUS) - H67-1 (RBUS) | Always | Below 1 Ω |
| P9-4 (RBBU) - H67-23 (RBBU) | Always | Below 1 Ω |
| H67-21 (RBUG) - Body ground | Always | 10 kΩ or higher |
| H67-1 (RBUS) - Body ground | Always | 10 kΩ or higher |
| H67-23 (RBBU) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE REAR AIR MIX DAMPER SERVO SUB-ASSEMBLY |
Replace the rear air mix damper servo sub-assembly (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||