REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Headphone Terminal and Television Display |

| 1.CHECK HEADPHONES |
Check the malfunctioning headphones.
| Result | Proceed to |
| Malfunction in headphone terminal RH side | A |
| Malfunction in headphone terminal LH side | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - HEADPHONE TERMINAL RH) |
Disconnect the U13 television display assembly connector.
Disconnect the S7 headphone terminal RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-26 (HP2R) - S7-1 (HP2R) | Always | Below 1 Ω |
| U13-28 (HP2L) - S7-2 (HP2L) | Always | Below 1 Ω |
| U13-27 (SLD6) - S7-3 (SG8) | Always | Below 1 Ω |
| U13-26 (HP2R) - Body ground | Always | 10 kΩ or higher |
| U13-28 (HP2L) - Body ground | Always | 10 kΩ or higher |
| U13-27 (SLD6) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK TELEVISION DISPLAY ASSEMBLY |
![]() |
Remove the television display assembly connector still connected (Click here).
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-26 (HP2R) - Body ground | Audio sound being produced | A waveform synchronized with sound is output |
| U13-28 (HP2L) - Body ground |
| *a | Component with harness connected (Television Display Assembly) |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - HEADPHONE TERMINAL LH) |
Disconnect the U13 television display assembly connector.
Disconnect the S8 headphone terminal LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-12 (HP1R) - S8-1 (HP1R) | Always | Below 1 Ω |
| U13-14 (HP1L) - S8-2 (HP1L) | Always | Below 1 Ω |
| U13-13 (SLD5) - S8-3 (SG7) | Always | Below 1 Ω |
| U13-12 (HP1R) - Body ground | Always | 10 kΩ or higher |
| U13-14 (HP1L) - Body ground | Always | 10 kΩ or higher |
| U13-13 (SLD5) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK TELEVISION DISPLAY ASSEMBLY |
![]() |
Remove the television display assembly connector still connected (Click here).
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-12 (HP1R) - Body ground | Audio sound being produced | A waveform synchronized with sound is output |
| U13-14 (HP1L) - Body ground |
| *a | Component with harness connected (Television Display Assembly) |
|
| ||||
| OK | ||
| ||