POWER WINDOW CONTROL SYSTEM > Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch |

| 1.CHECK DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| B2311 is output | B |
| B2312 is output | C |
| B2313 is output | D |
| LIN communication system DTCs are output | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK MANUAL UP / DOWN FUNCTION |
Check that the manual UP/DOWN function using the power window regulator switch can operate the front passenger side door power window (Click here).
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (FRONT POWER WINDOW REGULATOR MOTOR RH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / P-Door Motor / Data List.
According to the display on the intelligent tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Door P/W Auto SW | Front passenger side power window auto UP/DOWN switch signal / ON or OFF | ON: Front passenger side power window auto UP/DOWN switch operated OFF: Front passenger side power window switch not operated | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW SWITCH RH - FRONT POWER WINDOW MOTOR RH) |
![]() |
Disconnect the L2 front power window regulator switch RH connector.
Disconnect the L3 front power window regulator motor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L2-8 (AUTO) - L3-4 (AUTO) | Always | Below 1 Ω |
| L2-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH |
![]() |
Remove the L2 front power window regulator switch RH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (AUTO) - 1 (GND) | AUTO UP/DOWN operation | Below 1 Ω |
|
| ||||
| OK | ||
| ||