Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE TAILPIPE ASSEMBLY


A204853
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe assembly from the 2 exhaust pipe supports.



3. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


4. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD)
(Click here)


5. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


C180588
  1. Put matchmarks on the rear height control sensor link and bracket.

  1. Remove the nut and disconnect the rear height control sensor link.



    C180589
  1. Disconnect the rear height control sensor connector.

  1. Remove the nut and rear height control sensor.



6. REMOVE REAR STABILIZER BAR
(Click here)


7. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH


C180604
  1. Disconnect the AVS connector (w/ AVS).



    C180767
  1. Remove the 2 bolts and nut and remove the rear shock absorber.