Home › Suspension › REAR SUSPENSION › REAR UPPER ARM

REAR UPPER ARM > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


C206452
  1. Temporarily install the rear upper control arm with the 3 bolts and 3 nuts.



2. CONNECT REAR SPEED SENSOR WIRE


C180785
  1. Connect the rear speed sensor wire with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the speed sensor connector.



3. INSTALL REAR BRAKE FLEXIBLE HOSE


C181276E01
  1. Install the rear brake flexible hose with the 3 bolts.

    Torque:
    for bolt A:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for bolt B:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



4. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C193405E01
  1. Apply lithium soap base glycol grease to the sliding part and seal surface of the 2 slide pins.



    C180572
  1. Install the 2 slide pins.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



5. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


C180589
  1. Install the rear height control sensor with the nut.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the rear height control sensor connector.



    C180588
  1. Align the matchmark on the rear height control sensor link and bracket.

  1. Install the rear height control sensor link with the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL REAR WHEEL

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }



7. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



8. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH
  1. Tighten the 3 bolts and 3 nuts.

    Torque:
    185 N*m{ 1886 kgf*cm , 137 ft.*lbf }



9. INSTALL FUEL TANK ASSEMBLY
(Click here)


10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)