Home › Suspension › REAR SUSPENSION › REAR UPPER ARM

REAR UPPER ARM > REMOVAL

for Preparation Click here



1. REMOVE FUEL TANK ASSEMBLY
(Click here)

HINT:
Remove the fuel tank before removing the left upper control arm.



2. REMOVE REAR WHEEL


3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


C180588
  1. Put matchmarks on the rear height control sensor link and bracket.

  1. Remove the nut and disconnect the rear height control sensor link.



    C180589
  1. Disconnect the rear height control sensor connector.

  1. Remove the nut and rear height control sensor.



4. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C180572
  1. Remove the 2 slide pins.

  1. Remove the cylinder from the rear disc brake cylinder mounting.



5. SEPARATE REAR BRAKE FLEXIBLE HOSE


C181276
  1. Remove the 3 bolts and disconnect the rear brake flexible hose.



6. DISCONNECT REAR SPEED SENSOR WIRE
  1. Disconnect the rear speed sensor connector.



    C180785
  1. Remove the 4 bolts and disconnect the rear speed sensor wire.



7. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH


C206452
  1. Remove the 3 bolts and 3 nuts, and remove the rear upper control arm.