Home › Suspension › REAR SUSPENSION › REAR LOWER ARM (for No. 2 Arm)

REAR LOWER ARM (for No. 2 Arm) > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL NO. 2 REAR SUSPENSION ARM ASSEMBLY LH


C180773E01
  1. Align the matchmarks on the No. 2 rear suspension arm and adjusting cam.

  1. Temporarily install the No. 2 rear suspension arm with the bolt and nut.



    C180775
  1. Install the No. 2 rear suspension arm to the rear axle with a new nut.

    Torque:
    130 N*m{ 1326 kgf*cm , 96 ft.*lbf }

  1. Install a new cotter pin.



2. INSTALL REAR COIL SPRING LH
(Click here)


3. INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY LH (w/ Air Suspension)
(Click here)


4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



5. TIGHTEN NO. 2 REAR SUSPENSION ARM ASSEMBLY LH
  1. Tighten the bolt and nut.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)