Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type)

REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

    NEXT


    3.CUSTOMER PROBLEM ANALYSIS

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        5.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B



        B.
        Go to step 7
        A


        6.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Operation Check (Click here)

        2. Terminals of ECU (Click here)


        NEXT


        7.ADJUST, REPAIR OR REPLACE

          NEXT


          8.CONFIRMATION TEST

            NEXT

            END