Home › Engine / Hybrid System › 3UR-FE FUEL › FUEL FILTER

FUEL FILTER > REPLACEMENT

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. After discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
    2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the fuel pump ECU connector (Click here).

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch off.

    HINT:
    DTC P0171/0174 (system too lean) may be set.

  1. Crank the engine again, and then check that the engine does not start.

  1. Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.

  1. Connect the fuel pump ECU connector (Click here).



2. REMOVE NO. 1 FUEL TUBE SUPPORT PROTECTOR


    A207185
  1. Remove the 2 bolts, nut and No. 1 fuel tube support protector.



3. DISCONNECT FUEL MAIN TUBE


    A207244
  1. Using a union nut wrench, disconnect the fuel main tube and No. 2 fuel main tube from the fuel filter.



4. REMOVE FUEL FILTER ASSEMBLY


    A207245
  1. Remove the bolt, detach the clamp and remove the fuel filter.



5. INSTALL FUEL FILTER ASSEMBLY


    A207245
  1. Attach the clamp to install the fuel filter, and then install the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



6. CONNECT FUEL MAIN TUBE


    A207244
  1. Using a union nut wrench, connect the No. 2 fuel main tube and fuel main tube to the fuel filter.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



7. INSTALL NO. 1 FUEL TUBE SUPPORT PROTECTOR


    A207185
  1. Install the No. 1 fuel tube support protector with the nut and 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



8. INSPECT FOR FUEL LEAK
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  1. Turn the intelligent tester main switch ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.