BLIND SPOT MONITOR SYSTEM > Power Source Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Blind Spot Monitor Master or Blind Spot Monitor Slave / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Power Supply Voltage | Power supply voltage / Min.: 0 V, Max.: 50 V | 11 to 14 V | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Power Supply Voltage | Power supply voltage / Min.: 0 V, Max.: 50 V | 11 to 14 V | - |
| Result | Proceed to |
| The power supply voltages of the master and slave side sensors of the blind spot monitor system are both normal. | A |
| The power supply voltage of the master side sensor of the blind spot monitor system is abnormal. | B |
| The power supply voltage of the slave side sensor of the blind spot monitor system is abnormal. | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BATTERY) |
Disconnect the P25 blind spot monitor sensor RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| P25-5 (BRB) - Body ground | Ignition switch ON | 11 to 14 V |
| P25-5 (BRB) - Body ground | Ignition switch off | Below 1 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BODY GROUND) |
Disconnect the P25 blind spot monitor sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P25-1 (BRGD) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BATTERY) |
Disconnect the O46 blind spot monitor sensor LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O46-5 (BLB) - Body ground | Ignition switch ON | 11 to 14 V |
| O46-5 (BLB) - Body ground | Ignition switch off | Below 1 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND) |
Disconnect the O46 blind spot monitor sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O46-1 (BLGD) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||