Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB2    Short to GND in Outer Mirror Indicator(Master)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a ground short in the blind spot monitor indicator RH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB2
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output from the blind spot monitor sensor to the indicator is low for a certain amount of time.
  1. Harness or connector
  2. Outer rear view mirror assembly RH
  3. Outer rear view mirror glass RH
  4. Blind spot monitor sensor RH

WIRING DIAGRAM


E221720E03


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR
  1. Disconnect the P25 blind spot monitor sensor RH connector.

  1. Disconnect the L6 outer rear view mirror assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L6-9 (BSR+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT OUTER REAR VIEW MIRROR GLASS RH (BLIND SPOT MONITOR INDICATOR RH)


    B286082E02
  1. Remove the outer rear view mirror glass RH (Click here).

  1. Check the outer rear view mirror indicator.

    1. Apply battery voltage to the outer rear view mirror glass RH (outer rear view mirror indicator RH) and check that the outer rear view mirror indicator turns on.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → Terminal 7 (+)
      Battery negative (-) → Terminal 5 (-)
      Indicator turns on



NG
REPLACE OUTER REAR VIEW MIRROR GLASS RH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR
  1. Disconnect the l6 outer rear view mirror glass RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P25-6 (OMIR) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH (Click here)
OK

REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)