DTC C1AB2 Short to GND in Outer Mirror Indicator(Master) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1AB2 | With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output from the blind spot monitor sensor to the indicator is low for a certain amount of time. |
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR |
Disconnect the P25 blind spot monitor sensor RH connector.
Disconnect the L6 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L6-9 (BSR+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT OUTER REAR VIEW MIRROR GLASS RH (BLIND SPOT MONITOR INDICATOR RH) |
![]() |
Remove the outer rear view mirror glass RH (Click here).
Check the outer rear view mirror indicator.
Apply battery voltage to the outer rear view mirror glass RH (outer rear view mirror indicator RH) and check that the outer rear view mirror indicator turns on.
| Connection | Specified Condition |
| Battery positive (+) → Terminal 7 (+) Battery negative (-) → Terminal 5 (-) | Indicator turns on |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR |
Disconnect the l6 outer rear view mirror glass RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P25-6 (OMIR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||