Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1ABA    Blind Spot Monitor Slave Module Connection Incorrect

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor LH stores this DTC when terminal No. 3 of the blind spot monitor sensor LH is not connected properly, or the blind spot monitor sensor is not installed on its correct side and the wire harness that is connected to the blind spot monitor main switch assembly (warning canceling switch assembly) is connected to terminal No. 3 of the blind spot sensor LH.

DTC Code
DTC Detection Condition
Trouble Area
C1ABA
There is an open in the ground circuit (Terminal No. 3) of the blind spot monitor sensor LH for a specified period of time.
  1. Harness or connector
  2. Blind spot monitor sensor LH

WIRING DIAGRAM


E224406E02


INSPECTION PROCEDURE

NOTICE:
  1. After completing this inspection procedure, make sure to clear DTCs.
  2. When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CONFIRM PART NUMBER AND IDENTIFICATION MARK
  1. Confirm whether the blind spot monitor sensors are installed to the correct side or not.

    1. Check if the part number and identification mark of the blind spot monitor sensor on the vehicle is correct.

      OK:
      The part number and identification mark is correct.



NG
INSTALL BLIND SPOT MONITOR SENSOR TO CORRECT SIDE (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND)
  1. Disconnect the O46 blind spot monitor sensor LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O46-3 (LGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O46-3 (LGND) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)