Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U0232    Lost Communication with Blind Spot Monitor Slave Module

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH judges that there is a communication problem with the blind spot monitor sensor LH.

DTC Code
DTC Detection Condition
Trouble Area
U0232
The blind spot monitor sensor RH cannot receive signals from the blind spot monitor sensor LH.
  1. CAN communication system
  2. Blind spot monitor sensor LH
  3. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.REPLACE BLIND SPOT MONITOR SENSOR LH
  1. Replace the blind spot monitor sensor LH (Click here).


NEXT


3.RECHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

END (BLIND SPOT MONITOR SENSOR LH IS DEFECTIVE)